Firstly, what is wave soldering machine?
Wave soldering is a soldering process that involves pumping or electromagnetically propelling molten solder, typically a lead-tin alloy, to create the required solder wave. This wave of solder is designed to enable the mechanical and electrical connection between the component leads or pins and the solder pads on a pre-loaded printed circuit board. Wave soldering allows the soldering surface of through-hole components to directly contact the high-temperature liquid solder to achieve the soldering purpose. The high-temperature liquid solder forms a sloping surface and is manipulated by specialized equipment to create a series of wave-like formations, hence the name "wave soldering." The primary material used in this process is solder wire or solder bar.
Casing Description:
For DIP components on the PCB, after wave soldering, there is insufficient solder fill in the holes, resulting in solder joints that do not meet IPC Class 2 standards.
IPC Class 2 Standard:
The IPC-A-610 standard specifies the Class 2 standard for solder connections through holes. It requires a minimum of 75% vertical fill of solder and allows for a maximum of 25% concavity, including both the primary and secondary sides
After using E company's inspection tool, the X-RAY inspection results are as follows:
"Why do we have voids without solder? Let's take a look at the places with these virtual soldering points. They are all locations where through-hole components are placed too close to SMD components, as shown below."
"Let's take another look at the customer's Gerber files. The original design is as shown in the following diagram:"
There was a Inadequate safety clearance with multiple soldering points only about 0.72mm apart, results in extended rework time and increased customer costs
The process of carrier opening creates a certain shadow effect, and the higher the components and the closer the spacing, the more pronounced this shadow effect becomes, increasing the risk of poor quality.
Some say that using a soldering iron with added solder is sufficient, but is that really the case?" asked Xiao Die.
Soldering iron quality is not as good as wave soldering, with issues related to solder climbing. It can also impact lead times.
Here is sincere advice from the SMT factory:
For backside DIP pin feet to SMD component distance standards: When the component height ≤ 3mm, the distance (x) between the backside DIP pin feet and SMD components should be ≥ 3mm.
The higher the SMD components are and the more they are spaced from DIP components, the greater the necessary safety clearance. It should be at least ≥ 5mm."
as result, the establishment of quality is closely related to design





